Generic A1278 Trackpad with Cable Touchpad Screw fit for Macbook Pro Unibody 13″

If a MacBook Pro trackpad stopped clicking there are a few things you can try to troubleshoot and repair the problem.This could be related to:1. Failing (swollen) battery.2. Wrongly adjusted trackpad screw.3. Failed trackpad.If you are sure you MBP 13.3 is cased by trackpad , replace it,Such as Cracked, Broken
Mackbook Pro trackpad Adjustment screw, Philips screws secure the trackpad to the under belly of the top case. T5 screw sets how much play, or give, the trackpad has when you press it down. In other words, you use this screw to calibrate how far the trackpad is depressed when you perform the click action.
Package: A1278 trackpad + A1278 trackpad cable + screws set without Screwdriver

Share for 10% Discount (Please wait 10 sec after your sharing)

Send to a friend

Category: .

Product Description


Attention all through Replacement

This is where I had the so much problems: I just couldn’t get the set depth right.  If you screw it in too some distance then there’s no give but too much way it doesn’t work right either.  I had to reassemble and disassemble three times to get this best.
Something I wish I did before disposing of the old screw from the old best case was once noting how some distance it was once screwed in.  taken a picture first so I knew how some distance to screw in the new T5 on the new best case.  Don’t make that mistake.
While disposing of the four tiny screws, give a boost to the trackpad on the bottom with your fingersavoiding dropping off
Turning the screw counterclockwise will loosen the trackpad.
Turning it clockwise will  tighten the trackpad.
Make sure all gaps between the trackpad and palm rest are equal.

Compatibility
All Mid 2009- mid 2012 thirteen” A1278 Unibody MacBook Pros
(mid2009 mb990 mb991; mid2010 mc374 mc375; early 2011 mc799 mc724; past due 2011 md313 md314; md2012 md101 md102)
Tools

Phillips #00 screwdriver to do away with ten screws secur
If a MacBook Pro trackpad stopped clicking there are some things you’ll be able to attempt to troubleshoot and service the issue.This may well be associated with:1. Failing (swollen) battery.2. Wrongly adjusted trackpad screw.3. Failed trackpad.In case you are sure you MBP 13.3 is cased by trackpad , replace it,Such as Cracked, Broken
Mackbook Pro trackpad Adjustment screw, Philips screws safe the trackpad to the underneath belly of the best case. T5 screw sets how much play, or give, the trackpad has when you press it down. In other words, you use this screw to calibrate how some distance the trackpad is depressed when you carry out the click action.
Package: A1278 trackpad + A1278 trackpad cable + screws set with out Screwdriver
Special tools are vital at the same time as Macbook Pro A1278 trackpad replacement but no longer included – Phillips #00 screwdriver (to take away ten screws securing the lower case to the higher case and touchpad screw)?T6 Torx screwdriver( to take away six screws securing fan to the logic board and nine screws mounting the primary board)?Tri-wing screwdriver (to take away two Tri-wing screws securing the battery to the higher case)
Compatibility: All Mid 2009- mid 2012 thirteen” A1278 Unibody MacBook Pros (mid2009 mb990 mb991; mid2010 mc374 mc375; early 2011 mc799 mc724; past due 2011 md313 md314; md2012 md101 md102)
[amz_corss_sell asin=”B01B0PRCK4″]

Translate »